Article The current location: Home > Video Collection > measurement of surface tension of PLA for 3D printer using contact angle meter SL200K

measurement of surface tension of PLA for 3D printer using contact angle meter SL200K

Number of hits:4369    Release time:2020-08-25 00:00:00

 In this video, we show you surface tension of PLA for 3D printer. We used contact angle meter SL200K with high temperature chamber and high temperature syringe (max temp. about 450℃) to measure surface tension of melted PLA for 3D printer under temperature about 250-280℃ based on pendant drop method. And, we used ADSA-Realdrop method from CAST3.0 disigned by USA KINO to calculate surface tension of melted PLA for 3D printer. We found out that it is hard to form a shape of pendant drop under suggested melted temperature (about 190-220℃), and shape of melted PLA is hard to be controlled to form a drop shape. So, measured value of melted PLA for 3D printer (about 36-42mN/m) is just a reference for you, and we suggest you measure SFE for PLA, and then check out if measured value used melted PLA way is suitable. Visit http://www.uskino.com to find more information about contact angle meter.

 

Hot keywords of USA KINO:contact anglecontact angle measurement,  contact angle meter,  contact angle goniometer,  surface tensiometer, interfacial tensiometer,  surface tension measurement,  surface tension, surface tensiometry, contact angle measurement equipment and device, calculating surfac free energy, Determining Critical Micelle Concentration (CMC) of surfactant, made in China Method for choosing surface tensiometer NEW Method for choosing contact angle meter (goniometer) NEW Method for choosing interfacial tension meter NEW

Manage  technical support: www.chem17.com   GoogleSitemap

MainPro : contact angle,contact angle meter,contact angle goniometer,surface tension,surface tensiometer

Copyright © 2020 KINO Scientific Instrument Inc.  ICP:
Telephone
  • +1 (857) 626-5666